RODE NT6 Microfoon

The RDE NT6 is specifically designed for difficult mounting applications. Although clearly relevant to instrument miking, the new NT6 is extremely well suited to any situation where a small 'unobtrusive' but powerful microphone system is required.
The 1/2 (externally biased) gold sputtered capsule is designed to attach to a custom made, multi-position swivel mount allowing it to be independently positioned with ease. The capsule is connected to the remote pre-amplifier (body) by a custom 3m Kevlar fibre reinforced cable.
The surface-mount pre-amplifier circuit also incorporates a two position variable pad: 0 dB and -10 dB attenuation, and a 2-position variable high-pass filter that enables you to step from a flat response to 80Hz high pass filter; both conveniently located away from the capsule, providing additional control without the need to move the capsule once in position.

• Externally biased condenser


• Gold sputtered 1/2 capsule


• Two position PAD - 0dB and -10dB


• Two position High-Pass Filter - flat and 80Hz


• Convenient two-axis swivel mount and 3m Kevlar fibre reinforced cable included


• Heavy-duty satin-nickel plated body


• Surface mount circuitry


• Low noise and full frequency response

Power
P48 (48V), P24 (24V) phantom supply


Acoustic Principle
Pressure gradient


Directional Pattern
Cardioid


Frequency range
40Hz-20kHz, selectable HPF @ 80Hz/12dB/octave


Output impedance
200O


Signal noise ratio
75 dB SPL (A - weighted per IEC651)


Equivalent noise
19 dB SPL (A - weighted per IEC651)


Maximum SPL
135dB SPL (@ 1kHz, 1% THD into 1KO load) (145dB with maximum PAD)


Maximum output voltage
+6dBu (@ 1kHz, 1% THD into 1KO load)


Sensitivity
-37 dB re 1 Volt/Pascal (16 mV @ 94 dB SPL) +/- 2 dB @ 1kHz


Weight
386gm


Dimensions
188.4mmH x 64mmW x 20mmD



Product Id/EAN: 4977